C&M Britony FlexiFlu, Инструкции по установке и обслуживанию

Страница: 22 / 24

FAULT FINDING CHART FOR BRITONY FLEXIFLUE
22
P PR RO OB BL LE EM M C CA AU US SE E R RE EM ME ED DY Y
E Ex xp pllo ossiiv ve e IIg gn niittiio on n II))
Pilot too small Check pilot tube and injector
IIII)) Slow ignition not adjusted Check and adjust (see 5.3)
G Ga ass cco on nttrro oll tta ap p ssttiiffff II))
Grease dried Clean and regrease
((U
Usse err’’ss))
IIII)) Operating mechanism replaced
incorrectly Refit
L Lo ow w W Wa atte err T Te em mp pe erra attu urre e II)) Water rate too high Check water governor
IIII)) Insufficient gas flow Clean rate and it user’s tap is open
IIIIII)) Water governor sticking Remove and clean or replace (see 6.7)
IIV V)) Incorrect venturi Replace (3.65 mm) (see section 7.4)
V V)) Main burner injector dirty Clean or replace (see section 6.2)
B Bu urrn ne err sstta ay yss o on n II)) Air in pipework Check for dead legs
IIII)) Gas valve stays open Clean and grease gas spindle
IIIIII)) Dirt on gas valve facing Strip and clean gas valve
IIV V)) Dirt or foreign matter in water (See Section 6.6)
section
V V)) Loose jumper on house stop tap Clean water section
V VII)) Check-valve fitted on supply pipe (See Section 4.1)
V VIIII)) Slow ignition device stock Clean or replace (see Section 5.3)
Y Ye ellllo ow w F Flla am me ess-- II)) Heating body fins blocked Remove heating body and clean (see 6.4)
S So oo ott F Fo orrm me ed d IIII)) Primary air supply restricted Check burner manifold and clean (see 6.2)
IIIIII)) Wrong injectors Check injector sizes and gas rates
(see Section 1.3) technical data
U Un nsstta ab blle e F Flla am me e II)) Fan not switching to high speed See Section 8.6
IIII)) Water in gas line Drain and purge
IIIIII)) Faulty flue Check terminal position and flue ducts
(see Section 3.3)
IIV V))
Fan assy not fitted correctly Fit fan assy correctly (see Section 7.7)
V V))
Gaskets not fitted correctly Fit gaskets correctly (see Section 3.5)
H He ea attiin ng g B Bo od dy y N No oiisse e II)) Scale Descale heating body
IIII))
Excessive gas Check gas pressure (see 1.3 and 5.2)
IIIIII))
Insufficient water flow See section 8.15
F Fa an n N No oiissy y II)) Fan remaining at high speed See Section 8.3
IIII))
Fan out of balance Replace (see 7.7)
IIn nssu uffffiicciie en ntt W Wa atte err II)) Water service tap closed Check it is fully opened (see 3.5)
IIII)) Blocked venturi Remove and clean venturi (see 7.4)
IIIIII))
Low water pressure Check water pressure (see Section 1.3)
IIV V))
Water governor faulty Change governor
V
V))
Water governor sticking Remove and clean or replace (see 6.7)
V VII)) Foreign matter in water section Remove and clean (see Section 7.4)
V VIIII)) Water filter blocked Remove and clean/replace (see 3.5)
8 8..7 7..
8 8..8 8..
8 8..9 9..
8 8..1 10 0..
8 8..1 11 1..
8 8..1 12 2..
8 8..1 13 3..
8 8..1 14 4..
8 8..1 15 5..