10
3
3..6
6 G
Ga
ass C
Co
on
nn
ne
eccttiio
on
n
- Fit the gas service cock provided using the fine fil-
ter/washer to seal the connection. Fit the nut and
olive onto the 15 mm gas supply pipe and tigh-
ten, (see fig. 9).
- Test the complete gas installation for soundness
and purge.
3
3..7
7 W
Wa
atte
err C
Co
on
nn
ne
eccttiio
on
nss
- Remove the plastic covers protecting the water
inlet and the water outlet connections.
- Fit the water service cock provided to the right hand
connection at the bottom of the appliance using the
coarse filter/washer to seal the connection, (see fig.
10).
- Fit the nuts and olives onto the supply and delivery
pipes.
- Connect the inlet supply to the water service cock and
tighten.
- The water service cock supplied with the appliance
incorporates a drain plug.
- Ensure that all water connections are fully tightened.
3
3..8
8 E
Elle
eccttrriicca
all cco
on
nn
ne
eccttiio
on
nss
3
3..8
8..1
1 P
Prre
essssu
urre
e S
Sw
wiittcch
h
- Connect the wires at the top of the appliance to
the pressure switch, (see fig. 11).
- The
g
grre
ey
y
wire is connected to normally closed (NC
1) contact.
- The
p
piin
nk
k
wire to the normally open (NO 2)
contact.
- The
v
viio
olle
ett
wire to the common (P) contact.
- Fit the flue turret cover passing the wire through
one fo the slots provided and secure with the
screws provided.
- See figure.
3
3..8
8..2
2 M
Ma
aiin
nss C
Co
on
nn
ne
eccttiio
on
n
- Pass 0.75 mm
2
heat resisting cable through cable
gland.
- The earth wire (open yellow) must be connected
to the earth pillar (
) (see fig. 12).
- The live (brown) and neutral (blue) should be
connected as indicated into the terminal block.
- Check that component plugs are pushed home.
- Check for continuity, polarity and earthing.
F
Fiig
g.. 9
9
F
Fiig
g.. 1
10
0
F
Fiig
g.. 1
11
1
F
Fiig
g.. 1
12
2
G
V
P
