PARTS TO BE INSTALLED
rbl2014-004-066_a
1. LH storage compartment cover
2. LH storage compartment
Step 1: Install locking tie mount
Step 2: Install grommet in cover
Step 3: Insert wiring through hole in storage compartment side
Step 4: Install grommet in compartment side
Step 5: Install locking tie loosely
NOTE:
Tighten locking tie only after wiring is
passed through hole in storage compartment and
adjusted for length to prevent wiring from being
pinched by cover closure. However, wiring must
be sufficiently long to prevent tension on wires
when cover is opened.
rbl2014-004-068_a
Step 1: Connect colored wires together
Step 2: Connect black wires together
Step 3: Install locking tie mount
Step 4: Install locking tie
4. Repeat steps for right side turn signal light in-
stallation.
5. Turn vehicle power on and ensure turn signal
lights are functioning correctly.
6. Install all parts removed from vehicle in reverse
order of disassembly however, pay attention to
the following:
– Tighten all panel screws as specified.
– Install plastic washers on top 4 screws of up-
per rear storage compartment panel.
rbl2014-004-055_b
1. Plastic washers (x4)
2. Retaining screws (x4)
TIGHTENING TORQUE
Panel retaining screws
3.5 N•m ± 0.5 N•m
(31 lbf•
in
± 4 lbf•
in
)
Antenna
Antenna With Self-Locking Product
rbl2011-001-005_a
1. Self-locking product already applied
Install the antenna on the RH side of the rear cargo
module and tighten as specified.
SPECIFIED TORQUE
Antenna
1.5 N•m (13 lbf•
in
)
Install antenna grommet shipped in rear cargo
compartment around base of antenna.
PREDELIVERY
2014-1
33 / 52
