BASIC PROCEDURES
rmr2008-030-004_c
A. Smooth adjustment (position 1)
B. Hard adjustment (position 7)
NOTE:
Never adjust the rear shock
absorber cam from position 7 directly
to position 1 as it will restrain access
to adjustment holes and prevent you
adjusting the suspension.
rmr2008-030-004_d.eps
AVOID ADJUSTING CAM POSITION 7
DIRECTLY TO POSITION 1
A. Position 1
B. Position 7
RECOMMENDED REAR SHOCK
ADJUSTMENT
LOAD
CAM POSITION
68 kg (150 lb) rider
1, 2
91 kg (200 lb) rider
3 – 5
Rider with
passenger
6, 7
License Plate Installation
When a license plate needs to be in-
stalled or replaced, ensure to install
two new damping pads (P/N 293 740
028) on plate to be installed.
rmo2008-002-009
DAMPING PAD (P/N 293 740 028)
Refer to the following procedure for
proper installation.
1. Remove existing plate on vehicle (if
applicable).
2. Position new damping pads over
existing pads on vehicle plate sup-
port.
rmo2008-002-010_a
TYPICAL
1. Existing pads on plate support
3. Peal off backing of new damping
pads.
rmo2008-002-009_a
TYPICAL
1. backing
4. Secure upper portion of license
plate using existing hardware on
vehicle plate support.
_____________________
25
Содержание spyder gs 2008
