MAINTENANCE PROCEDURES
Drive Belt Wear
Inspect the drive belt with the vehicle
in neutral, engine off, on a level surface
with plenty of room – you will have to
roll the vehicle forward or backward to
see the full length of the belt.
rmo2008-001-109_a
DRIVE BELT SURFACES
1. Outer surface
2. Teeth side surface
3. Tooth
Inspect for the following conditions:
WEAR CONDITION
REQUIRED ACTION
Good condition
None
Hairline cracks
Monitor condition
Minor chipping
Monitor condition
Opened cracks
Replace belt
Hook wear
Replace belt
Missing teeth
Replace belt
Belt fabric worn, exposing internal
components
Replace belt
Stone damage
Replace belt
NOTE:
Hairline cracks do not require the replacement of the belt, but must be
monitored closely – they may lead to opened cracks or missing teeth, requiring
belt replacement. Damage to the center of the belt will eventually require belt
replacement, but when cracks extend to the edge of the belt, belt failure is immi-
nent.
When a drive belt is replaced, also replace the sprockets to increase the longevity
of the new drive belt.
_____________________
81
Содержание spyder gs 2008
