Campbell CR23X, Руководство оператора

Страница: 64 / 374

SECTION 3. INSTRUCTION SET BASICS
3-10
25 Compile ELSE without IF
26 Compile EXIT LOOP without
LOOP
27 Compile IF CASE without BEGIN
CASE
30 Compile IF and/or LOOP nested
too deep
31 Run Time SUBROUTINES nested
too deep
32 Compile Instruction 3 and interrupt
subroutine use same port
40 Editor Instruction does not exist
41 Editor Incorrect execution
interval
60 Compile Insufficient Input Storage
61 Compile Burst Measurement Scan
Rate too short
62 Compile N<2 in FFT
68 Compile Instruction 118 without
enough Instructions 68 or 63
80 Compile Valid entries for parameter 1
of P80 are 1, 2, 3 (-- is illegal)
92 Compile Instruction 92, intervals in
seconds: Time into Interval
> 59 or Interval > 60
93 Compile Save labels full
94
D
Mode Program Storage Area
full
95 D Mode Program does not exist in
Flash memory
96
D
Mode Addressed device not
connected or wrong
address (see Table 1.8-2)
97 D Mode Data not received within
30 seconds
98
D
Mode Uncorrectable errors
detected
99 D Mode Wrong file type or editor
error
101 TGT1 No response
102 TGT1 Bad Star Pound entry
105 Illegal Baud C5-C8
106 Illegal Channel C5-C8
107 Compile Second CSAT3
Instruction not nested