Campbell CNL100, Инструкция по эксплуатации

Страница: 16 / 34

NL100/105 Network Link Interface
10
RS-232 bps - This is the bits per second (bps) at which the NL100/105
will communicate using the RS-232 port. This is a fixed rate (i.e., it is not
a maximum baud rate or an autobaud rate). Note that the CR10(X) and the
CR510 can communicate at a maximum baud rate of 9600 bps, so to
communicate with one of those dataloggers, this setting must be 9600 bps
or less. The default setting is 115K bps.
RS-232 Serial Server AppId number - Enter the application ID, in the
range of 1 to 65000, that will be used to identify the PakSer in the
network. The default ID is 6784.
The usual AppId for MODBUS devices is 501.
ConfMon - Configuring the RS-232 port as a ConfMon allows you to connect
directly to the NL100/105 via a computer. There are no parameters; the baud
rate is automatically set to 115,200 bps. Refer to Section 3.2.1 for additional
information.
2.3.3.5 Ethernet 10 Base-T
The 10 Base-T communications link is used to connect the NL100/105 to a
TCP/IP network using a Category 5 twisted pair cable. The Ethernet 10 Base-T
link must be configured, or you will not be able to communicate with the
NL100/105 over a TCP/IP connection. The following options must be
configured. These values should be provided by your network administrator.
10BASE-T Port IP Address - This number is the address of the
NL100/105 on a TCP/IP network. It is written as 32-bit number written in
four 8-bit decimal-equivalent syllables separated by periods, in the format
XXX.XXX.XXX.XXX. The IP Address must be a static IP Address -- the
NL100/105 does not support DHCP (dynamic host configuration
protocol).
10BASE-T Port Network Mask - The network mask is used to help a
network router to more efficiently transfer information. Typically, a class
C mask will be 255.255.255.0, a class B mask will be 255.255.0.0, and a
Class A mask will be 255.0.0.0. The tighter the mask, the more the
NL100/105 will rely on the default gateway to route packets.
If you enter Yes for "Is there a default gateway", you will also need to
configure the following option:
IP Address of the Default Gateway - Enter the IP address of the device
that is responsible for forwarding information to destinations outside the
internal network, defined by the network mask.
2.3.3.6 PakBus Node ID
If the NL100/105 is to be used in a PakBus network, a PakBus Node ID must
be assigned. If the NL100/105 will not be used in a PakBus network, this
setting can be ignored. All devices in the network must have a unique PakBus
Node ID. Valid IDs are 1 through 4094. The default ID is 678.
NOTE