Campbell CNL100, Инструкция по эксплуатации

Страница: 19 / 34

NL100/105 Network Link Interface
13
Telnet session password: [nl100]
Serial server watchdog (minutes): [2]
This option is different from the Reset menu item. The Default menu item
resets the NL100/105 back to the factory defaults. Reset reboots the device
using the last-saved configuration.
After the NL100/105 reboots, it may take a few moments to reestablish
communication. Press enter a few times until the NL100/105 status line is
returned.
2.3.5 Reset
This option reboots the NL100/105, using the last saved settings that have been
programmed by the user. This option is different from the Defaults menu item.
The Defaults menu item resets the NL100/105 back to the factory defaults.
After the NL100/105 reboots, it may take a few moments to reestablish
communication. Press enter a few times until the NL100/105 status line is
returned.
When using the NL100/105 in a PakBus network, resetting the
NL100/105 (or making other changes to the network that might
change the known route to remotes), may result in lengthy
communication interruptions until the new routes can be learned
by all the devices in the network.
2.3.6 Help
The Help option provides tips for navigating within the NL100/105 menu
prompts and gives a brief description of each menu item. Help for a particular
setting can be displayed by pressing F1 or ? at the prompt for that setting.
2.3.7 Bye
The Bye option is used to close the Socket connection at the end of a Telnet
session.
3. Connecting the NL100/105 to a Network
3.1 Network to NL100 Connection
The connection from the computer network to the NL100/105 10 Base-T port
should be a twisted pair cable. A male RJ-45 plug connector should be on the
cable end going into the 10 Base-T port.
If the cable is to be run directly from the computer to the NL100/105, a
crossover cable is required. If the cable will be run from a hub to the
NL100/105, a straight through cable should be used. Appendix C shows the
pin-outs for these two cable types.
NOTE