CAMPAGNOLA POWER ECO, Руководство по эксплуатации и обслуживанию

Страница: 24 / 120

Use and Maintenance Manual – Translation of
Original Instructions Rev.: 03, Date 30/11/2021
Page 23
For a correct and clear identification of the tool, refer to the type, serial number and year of manufacture
shown on the identification plate and quote them for each intervention or assistance request to Campagnola
Srl.
The CE marking is unique and it certifies the conformity of the product with the machinery directive and the
other applicable directives in compliance with the conditions prescribed and shown in this manual.
In case of a “composite” machine/tool, a CE plate/label which identifies the type of tool (e.g. ATRA.xxxx)
composing the composite machine/tool is affixed to the product.
The customer is in charge of checking the integrity of the CE plate/label.
The user must replace the CE and/or warning plates which become illegible due to wear.
It is strictly forbidden to remove the plates/labels on the machine/tool. Campagnola S.r.l declines any re-
sponsibility on the safety of the machine/tool in case of non-compliance with this prohibition.
3.2 Product description
The electromechanical battery powered power units POWER 12 and POWER ECO are intended for harvesting tools.
The “products table” diagram (par. 2.1.1) summarises the range of products that are compatible with the power unit.
The power unit combined with the pole and the harvesting head constitutes the generic type of complete tool that is
intended for harvesting olives and coffee.
The power unit is powered by a 12V lead battery pack. The battery capacity (Ampere) only determines the operating
time. The power unit consists of the handle body and the gearmotor. The ON-OFF switch (7), which controls the
switching on and off of the tool, and a bright red LED (9), which indicates the on or off status, are found on the body of
the handle (1).
A connector (4) is fitted on the body, which connects the power unit with the battery pack via a power cable.
At the top of the handle body (1) there is a clamp (3) on which to fit the extension pole, fixed (12) or telescopic (11),
which transmits motion to the tool.
It must be noted that the tool was solely designed and built for the purposes mentioned above.
3.3 Supplied parts
- Use and maintenance manual.
3.4 Intended use
The tool has been designed and built to be used according to the above-described methods and limits.
• Any other use has to be considered improper and potentially dangerous for the operators’ safety. This
would make any warranty claims void.
• If the tool is used for purposes other than those listed, it may be seriously damaged and damage ob-
jects and persons.
DIRECTIVE 2012/19/EU ONLY APPLIES TO ELECTRIC AND ELECTRONIC TOOLS
AND/OR DEVICES (EEE).
THEREFORE, EVEN IF THE CE PLATE/LABEL SHOWS THE SYMBOL OF A CROSSED
OUT BIN, THIS DIRECTIVE DOES NOT APPLY TO PNEUMATIC PRODUCTS NOT
EQUIPPED WITH AN EEE.