6
• Do not block holes in bottom or sides of
appliance.
• Never operate appliance with LP tanks out
of correct position specified in Assembly
Instructions.
WARNING: Hose is a trip hazard.
2 IN. (50MM) MIN
• Always close LP tank valve and remove
coupling nut before moving LP tank from
specified operating position.
• NEVER store a spare LP tank under or near
appliance or in enclosed areas. NEVER fill
the cylinder beyond 80% full. An overfilled
spare LP tank is hazardous due to possible
gas released from the safety relief valve.
Failure to follow these instructions exactly
could cause a fire resulting in death or
serious injury.
• If you see, smell, or hear escaping gas,
immediately get away from the LP tank/
appliance and call your fire department.
• All spare LP tanks must have safety caps
installed on the LP tank outlet.
LP Tank Removal, Transport and Storage
• Turn OFF all control knobs and LP tank
valve. Turn coupling nut counterclockwise by
hand only – do not use tools to disconnect.
Place dust cap on cylinder valve outlet
whenever cylinder is not in use. Only install
the type of dust cap on the cylinder outlet
valve that is provided with the cylinder valve.
Other types of caps or plugs may result in
leakage of propane.
• A disconnected LP tank in
storage or being transported
must have a safety cap
installed (as shown).
Do not store an LP tank in enclosed spaces
such as a carport garage, porch, covered
patio or other building. Never leave an LP
tank inside a vehicle, which may become
overheated by the sun.
• Do not store LP tanks in an area where
children play.
• When the appliance is not in use, the
gas must be turned off at the supply
cylinder. Storage of the appliance
indoors is permissible only if the cylinder
is disconnected and removed from the
appliance.
• Supply cylinders must be stored outdoors
out of the reach of children, and shall not
be stored in a building, garage, or any other
enclosed area.
• Storage of an appliance indoors is
permissible only if the cylinder is
disconnected and removed from the
appliance.
LP Tank
The LP tank used with your appliance must
meet the following requirements:
• The tank must be approximately 31.1 cm /12
in diameter x 46 cm /18.25 in tall with a
marked 9.07 kg / 20 lb LPG capacity or 21.6
kg / 47.6 lb water capacity as stated by the
tank manufacturer.
• Be constructed and marked in accordance
with specifications for LP tank of the U.S.
Department of Transportation (DOT) or the
National Standard of Canada, CAN/CSA-
B339, Cylinders, Spheres and Tubes for the
Transportation of Dangerous Goods.
• The propane cylinder used with this
appliance must include a collar to protect the
cylinder valve.
LP tank valve must have:
• Type 1 outlet compatible with regulator or
appliance.
• Safety relief valve.
• UL listed Overfill
Protection Device (OPD).
This OPD safety feature
is identified by a unique
triangular hand wheel.
Use only tanks equipped
with this type of valve.
Dust Cap
OPD Hand
Wheel
50 MM (2 IN) MIN