D U P
L
I C
A
T
E
5
Preparation
for Start-up
Preliminary Operations and Cleaning
Remove the protective paper.
Make sure that the transportation has not caused any damage to the machine.
Release upper counterweights DS (fig. 1) and check nylon cord FL (fig. 1) for
correct winding on the pulley.
Remove central cover plate C3 (fig. 1) and fasten lower counterweight D; check
the nylon cord for correct winding on the idler (fig. beside).
Make sure that scrap pan CS (fig. 1) is correctly fitted.
Cleaning
1 Remove guide plate guard (fig. 1)
2 Remove the ball pins AG (fig. beside)
3 Remove upper guide plate PAS (fig. 1)
4 Clean upper guide plate PAS (fig. 1) and all the machine surfaces coated with
grease
5 To remount the plate proceed in reverse order
6 Release upper knife back guide wedges CUS by removing knob P4 (fig. 1)
7 Fasten counterweights DS (fig. 1) and check nylon cord FL for correct winding on
the pulleys
8 Release lower counterweight D by loosening knob P6 (fig. beside)
Carrefully clean the knife surfaces and the knife wheel contact surface; remove the
protective lubricant.
Mount feed table PEM (fig. 1) and fasten with knobs P3.
Preparation for Start-up 5-1
P6
D
AG