5
CAMEC ELITE
®
2
EM303
Ref: ELITE 2 EM303-0715Rev.A.
INTRODUCTION
Congratulations on choosing the
Camec Elite
®
2
EM303 caravan manoeuvring system. This has been produced
according to very high standards and has undergone careful quality control procedures.
By using the remote control handset you can move your caravan effortlessly into any position required within
operating guidelines. Soft start and soft stop technology allows you to manoeuvre your caravan accurately without
any shocks.
The caravan manoeuvring system consists of two 12V motor-power rollers, a 12V electronic control unit and a
remote control handset. To function, the motor-powered rollers must be engaged against the tyres of your caravan.
The supplied cross actuation device enables you to engage both rollers at the same time from one side of your
caravan. Once this is done, the manoeuvring system is ready for operation. The remote control will allow you to
move your caravan in any direction. You can even rotate the caravan on its own axis, (function not compatible with
double axle caravans) without moving forwards or backwards.
Before proceeding with installation and starting to use the manoeuvring system, please read
this manual very carefully and be aware of all the safety instructions! The owner of the caravan
will always be responsible for correct use. Keep this manual inside your caravan for future
reference.
INTENDED USE
The
Camec Elite
®
2
EM303 caravan manoeuvring system is suitable for single axle and double axle caravans.
Suitable only
for
L-profiled
and
U-profiled
chassis with
a
chassis thickness
between min.
2.8mm and
max.
3.5mm.
Depending on the weight of the caravan, the manoeuvring system cannot overcome obstructions that are more
than about 2cm in height without assistance (please use wedges as a ramp).
The standard installation kit only provides parts for installing the caravan manoeuvring system within the
measurements given in Fig. 2.
SPECIFICATIONS
Designation
Camec Elite
®
2
EM303
Operational voltage
12 Volt DC
Average current consumption
20 Ampere
Maximum current consumption
100 Ampere
Speed
approx. 9cm per sec.
Weight (2 motor set)
approx. 37kg (excludes battery)
Permissible overall Weight single axle (2 motors)
1800kg (1500kg on 18% gradient)
Permissible overall Weight double axle (2 motors)
1800kg (1500kg on 18% gradient)
Permissible overall Weight double axle (4 motors)
2500kg (1800kg on 18% gradient)
Minimum width (caravan/trailer)
1800mm
Maximum width (caravan/trailer)
2500mm
Maximum tyre width
205mm
Power source (battery)
LiFePO4: 12V, 20Ah (recommended
Camec Elite
®
2
EM303) Lead acid: 12V, 80Ah (min.)