19
CAMEC ELITE
®
2
EM303
Ref: ELITE 2 EM303-0715Rev.A.
•
Check the installation in accordance with the installation instructions
and ensure that the drive rollers are not applied. Check that the battery
is properly connected, check the condition of the battery and that a
voltage of 12V is present at the control unit.
•
Please ensure that the battery isolation switch is on.
•
Activate the remote control handset by sliding the slide switch to “On”-I
(Fig. 18A). The green LED on the remote control handset (Fig. 18H)
will start
to
flash
slowly.
•
Press the reset button
(Fig. 17A) on the control unit. All three LED’s on
the control unit
(Fig.
17B,
17C
&
17D)
will
flash
slowly.
•
Press both forwards (Fig. 18B) and reverse (Fig. 18C) button on the
remote control handset for about 3 seconds. The handset buzzer will
give a
short
beep
to
confirm that
the
synchronisation is
complete.
•
After successful synchronisation, the green LED on the control unit (Fig. 17B) and on the remote control
handset (Fig. 18H) will illuminate continuously.
The single-twin axle function switch
(Fig. 17S/T): The
Camec Elite
®
2
EM303 caravan manoeuvring system is
suitable for both single axle and twin axle caravans. You just need to move the single-twin axle function switch
(Fig 17S/T) on the control unit, so that the manoeuvring system can be used for a single-axle caravan or a twin-
axle caravan (for 2 motor use but also for 4 motor use). In the twin axle function, all wheels will drive, but at a
different speed.
The switch is pre-selected for single axle use
(Fig. 17S): For twin axle use, just move the switch to the twin axle
position (Fig. 17T). When move the single-twin axle function switch, the battery power isolation switch (29) must be
turned off.