p.
3
- M
an
ua
l
FA
010
80
-E
N
- 0
2/
20
18 - © C
AM
E S
.p
.A
. - T
ra
ns
la
tio
n o
f t
he o
rig
in
al i
ns
tru
ct
io
ns
will cease to be effective. • All maintained-action switches that are connected to the
control panel must be positioned so that the maneuvering area is completely visible from
the switches, yet far enough away from any moving parts. • Make sure that the operator
has been properly adjusted and that any associated safety and protection devices, as
well as the gearmotor's manual release, are working properly. • If the power-supply
cable is damaged, it must be replaced by the manufacturer or by the licensed technical-
assistance center or by duly trained, skilled staff, to prevent any risks. • During all
phases of the installation make sure you have cut off the mains power source. • The
electrical cables must run through corresponding tubes or conduits to ensure suitable
protection against mechanical damage and they must not come into contact with parts
that could heat up during use. • Make sure you have set up a suitable dual pole cut
off device along the power supply that is compliant with the installation rules. It should
completely cut off the power supply according to category III surcharge conditions. • If
the control panel is used for automating guided parts in residential settings, permanently
fit the entrapment-hazard-warning signage, so that it is clearly visible or close enough to
all command and control devices. After installing, make sure that the operator is properly
adjusted and that the guided part, in case it touches any object that is 50 mm high off
the ground, inverts its movement or that the object may easily be removed (for operators
that have built-in anti-entrapment systems that depend on coming into contact with the
lower edge of the guided part). Also make sure that the guided part does not extend
onto any public pedestrian passages or onto the street. • Store this manual inside the
technical folder, along with the installation manuals of the other devices in the system.
Remember to hand over to the end users all the operating manuals of the products that
make up the final machinery.
