M2
M1
M2
M1
M2
M1
M2
M1
Memory Roll
A B
S1 GND
<Taratura Corsa>
Taratura Corsa
Chiusura 1
Taratura Corsa
Chiusura 2
Taratura Corsa
Taratura Corsa
< Confermi?(si)>
Taratura Corsa
Apertura 2
Taratura Corsa
Apertura 1
Taratura Corsa
OK
p.
22
- M
an
ua
l
FA
010
80
-E
N
- 0
2/
20
18 - © C
AM
E S
.p
.A
. - T
ra
ns
la
tio
n o
f t
he o
rig
in
al i
ns
tru
ct
io
ns
For memorizing user and system configuration
data, then using them on another control board.
&
After memorizing the data, it is best to
remove the Memory Roll card while the control
board is in operation.
Memory Roll Card
Gate-swing calibration
⚠
Before calibrating the gate-swing, check that the maneuvering area is free from any obstruction and that there are both
opening and closing mechanical gate-stops.
⚠
The mechanical gate-stops are obligatory.
Important! During the calibration, all safety devices will be disabled except for the PARTIAL STOP one.
7. Once the procedure is completed,
the display will read
[Gate-Swing
Calibration OK]
for a few seconds.
6. ... after which, M1's gate leaf will
also perform a full opening.
5. ... and then M2's gate leaf will
swing open until it reaches the gate-
stop ...
4. ...then, M2's gate leaf will perform
the same closing...
3. M1's gate leaf will swing closed
until reaching the gate-stop...
2. Select
[Confirm?(yes)]
and press
ENTER to confirm.
1. From the
[ENCODER]
, select
[Calibrate Gate-Swing]
. Press
ENTER to confirm.
