P
age
34
- Manual
FA01554-EN
- 01/2021 - © C
AME S.p.A. - The contents of this manual may be changed at any time and without notice. - T
ranslation of the o
riginal instructions
Radio decoding
Choose the type of radio coding for the transmitters enabled to control the operator.
If you choose the type of radio coding for the transmitters [Rolling code] or [TW key block], any transmitters
saved previously will be deleted.
U4
Radio decoding
1 = All decoding (default)
2 = Rolling code
3 = TW key block
Self-Learning Rolling
Save a new rolling code transmitter by activating acquisition from a rolling code transmitter that has already been saved. The
saving and acquisition procedures are explained in the transmitter manual.
U8
Self-Learning Rolling
OFF (Default)
ON
Motor type
Set the type of gearmotor installed on M1 and M2.
A1
Motor type
1 = STYLO ME
2 = STYLO RME
4 = FAST-70
5 = AXI
7 = FERNI
8 = FERNI V
9 = AXO
10 = ATI
11 = FROG
12 = FROG E
13 = ATS
Motor test
Check the gate leaves open in the right direction.
With the function active, the > key opens the gate leaf connected to M2, and the < key opens the gate leaf connected to M1.
The movement continues while the key is pressed or until the end-of-travel limit switch is reached. When the key is released,
the movement stops.
If the leaf does not move in the correct direction, invert the motor phases.
The leaves will move at reduced speed.
A2
Motor test
----
Travel calibration
Start the travel self-learning.
A3
Travel calibration
OFF (Cancel operation)
ON (Run operation)
