P
age
36
- Manual
FA01554-EN
- 01/2021 - © C
AME S.p.A. - The contents of this manual may be changed at any time and without notice. - T
ranslation of the o
riginal instructions
Photocell BUS <n>
Associate a function with the photocell BUS <n> input.
<n> is between 1 and 8 and corresponds to the address set on the photocell dip-switch
B1-B8
Photocell BUS <n>
OFF (Default)
C1 = Reopen while closing (photocells)
C2 = Reclose while opening (photocells)
C3 = Partial stop Only with [Automatic close] activated.
C4 = Obstacle standby (photocells)
C13 = Reopen while closing, with immediate stop once
the obstruction has been removed, even if the gate is not
in motion
C23 = Open command
C24 = Close command
Saving and uploading user and configuration data
Save user data and system confi guration data on a MEMORY ROLL card.
The stored data can be reused for another control board of the same type to carry across the same confi guration.
Before inserting and removing the MEMORY ROLL card, DISCONNECT THE MAINS POWER SUPPLY TO THE LINE.
1
Insert the MEMORY ROLL card into the corresponding connector on the control board.
2
Press the “Enter” button to access programming.
3
Use the arrows to choose the desired function.
The functions are displayed only when a MEMORY ROLL card is inserted.
F50
-Save data
Save user data, timings and confi gurations to the memory device (memory roll or USB key).
F51
-Read data
Upload user data, timings and confi gurations from the memory device (memory roll or USB key).
Once the data have been saved and loaded, the MEMORY ROLL can be removed.
