Page
2
- Manual
FA00993-EN
- 12/2018 - © C
AME S.p.A. -
Tr
anslation of the original instructions
GENERAL PRECAUTIONS FOR INSTALLERS
⚠
Important safety instructions.
⚠
Follow all of these instructions. Improper installation can cause serious
bodily harm.
Use this product only for its specifically intended use. Any other use is hazardous.
• The manufacturer cannot be held liable for any damage caused by improper,
unreasonable, and erroneous use. • This product is expressly designed to be
assembled to partly-completed machinery or equipment so as to build machinery
as regulated by the Machinery Directive 2006/42/EC. • The final installation must
comply with the Machinery Directive 2006/42/CE and with the currently applicable
European standards. • The manufacturer declines any liability for using non-original
products; which would result in warranty loss • All procedures mentioned in this
manual must be only be performed by skilled, qualified technicians and in full
compliance with current regulations. • Laying of cables, installation and testing
must follow state-of-the-art procedures as dictated by applicable standards and
laws. • During all phases of the installation make sure you have cut off the mains
power source. • Check that the temperature ranges given and those of the location
match. • Before the installation, check that the guided part is in good mechanical
condition, and that it opens and closes correctly. • Take care not to wet the operator
with direct jets of water (sprinklers, water cleaners, etc.). • Make sure the anchoring
spot is clear of any potential impacts, that the anchoring surfaces are solid, and
that elements suitable for the type of surface (for example screws and wall plugs)
are used. • Make sure you have set up a suitable dual pole cut off device along the
power supply that is compliant with the installation rules. It should completely cut
off the power supply according to category III surcharge conditions. • Demarcate
properly the entire site to prevent unauthorized personnel to enter; especially children
and minors. • Use suitable protections to prevent any mechanical hazards due to
persons loitering within the operating range of the operator. • The electric cables
must pass through special pipes, ducts and cable glands in order to guarantee
adequate protection against mechanical damage. • The electrical cables must not
touch any parts that may overheat during use (such as the motor and transformer).
• All fixed controls must be clearly visible after installation, in position that the
guided part is directly visible, but far away from moving parts. In the case of a
maintained action command, this must be installed at a minimum height of 1.5 m
from the ground and must not be accessible to the public. • If not already present,
apply a permanent tag, that describes how to use the manual release mechanism,
close to the mechanism • Make sure that the operator has been properly adjusted
and that the safety and protection devices, and the manual release, are working
properly • Before turning over to the final user, check that the system complies
