CAME VER06DES, Руководство пользователя

Страница: 57 / 128

Page
25
- Manual
FA01742-EN
- 12/2021 - © CAME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - T
ranslation of the
original instructions
F 1 Total stop [1-2]
NC input – Door stop that excludes any automatic closing; to resume movement,
use the control device. The safety device is inserted into (1-2), if unused, select
OFF.
OFF =Deactivated ( default ) / ON =Activated
F 2 Input [2-CX]
Input NC - Can associate: C1 = reopening during closing by photocells, C3 =
partial stop, C4 = obstruction wait, C7 = reopening during closing by sensitive
safety-edges, r7 = reopening during closing by resistive sensitive safety-edges
8K2.
OFF = Deactivated (default) / C1 / C3 / C4 / C7 / r7

The C3 setting only appears if F19 is active.
F 3 Input [2-CY]
Input NC - Can associate: C1 = reopening during closing by photocells, C3 =
partial stop, C4 = obstruction wait, C7 = reopening during closing by sensitive
safety-edges, r7 = reopening during closing by resistive sensitive safety-edges
8K2.
OFF = Deactivated (default) / C1 / C3 / C4 / C7 / r7

The C3 setting only appears if F19 is active.
F 5 Safety test
After every opening or closing command, the board will check whether the
photocells are working properly.
OFF =Deactivated (default) / 1 =CX / 2 =CY / 4 =CX+CY
F 7
Control mode
on 2-7
The control device connected to 2-7, performs the (open-close-invert) step-
step, (open-stop-close-stop), sequential, open only or close only
0 = Step-step (default) / 1 = Sequential / 2 = Open / 3 = Close
F 9
Obstruction
detection with
motor stopped
With the door closed, open, or after a total stop, the gearmotor stays idle if the
safety devices, that is, the photocells, detect an obstruction.
OFF = Deactivated (default) / ON = Activated
F18 Additional light
Output for connecting the additional light onto 10-E.
Flashing light: it fl ashes when the door is opening and closing.
Cycle: it stays on from the moment the door starts opening until it is fully closed,
including the waiting time before the automatic closing.
Courtesy: it stays on for an adjustable time of between 60 and 180 seconds. To
set the time, see function F25.
0 = Flashing light ( default ) / 1 = Cycle / 2 = Courtesy
Functions menu

IMPORTANT! Start programming by fi rst performing the TOTAL STOP (F 1) and TRAVEL CALIBRATION
(A3) functions
Only program functions when the operator is stopped.

You can save up to 250 users.
p.
25
-
Ma
nu
al
FA01742-EN
- 12/2021 - © CAME S.p.A. -
Th
e c
onte
nts of th
is
m
an
ua
l m
ay b
e c
ha
ng
ed, at a
ny ti
m
e, a
nd w
ith
ou
t n
oti
ce
. - O
rig
in
al
in
str
ucti
on
s