p.
14
- Manual
FA01354-EN
- 07/2019 - © C
AME S.p.A. - The cont
ents of this manual may change, at any time, and without notice. - Original instructions
ELECTRICAL CONNECTIONS
Electric cables passage
The electrical cables must not touch any parts that may overheat during use (such as the motor and the transformer).
Make sure that the moving mechanical elements have adequate distance from the wiring made.
The cables must pass through the ferrite included in the supply.
1
1
Input voltage
Make sure the mains power supply is disconnected during all installation procedures.
Before working on the control panel, cut off the mains power supply and remove the batteries, if any.
Connecting to the electrical network
230 V AC
50/60 Hz
Accessories power supply output
10 11 E1 E6 TS 1
2
3 3P
Output delivers normally 24 V AC.
The output delivers 24 V DC when the batteries start operating, if they are
installed.
The sum of the connected accessories input must not exceed 40 W.
