p.
12
- Manual
FA01354-EN
- 07/2019 - © C
AME S.p.A. - The cont
ents of this manual may change, at any time, and without notice. - Original instructions
Fit the boom into the fastening flange
Tighten the screws firmly.
1
Cut the slot cover profiles of the same size as the boom slot minus 10 millimeters.
2
Insert the slot cover profiles in the appropriate grooves on both sides of the boom.
3
Fit the rubber terminal cap into the corresponding housing
4
Insert the anti-impact rubber profile into the groove, making it fit with the end cap.
5
Cut the excess part of the profile, letting it protrude of 7 millimetres.
6
Insert the end cap of the rubber profile into the groove of the boom closing cap. Use the screws to fasten the boom end cap.
7
Fit the anti-shearing protective cover onto the boom-attachment cover and fasten it using the screws supplied.
❶
❷
❸
❹
❺
❻
⚠
❼
Boom set up
Before adjusting the boom, check the accessories you want to fit and the passage clearance width.
Simple boom means the boom complete with slot cover, cap and rubber profile.
Passage width clearance / Duty-cycle
intermittence
< 2.5 m / 80%
< 2.5 m / 100%
2.5 < 2.75 m / 100%
from 2.5 a 3.8 m /
100%
Simple boom
A1 = 1
A1 = 2
A1 = 1
A1 = 2
Boom with LED STRIP
A1 = 1
A1 = 2
A1 = 1
A1 = 2
Balancing springs
NO
NO
A1 = 1
A1 = 2
001G02807 fixed rest MUST be used for passage clearance widths exceeding 3 m.
With A1 = 1, fast profile, the boom opening time varies from 1.2 to 2.5 seconds.
With A1 = 2, slow profile, the boom opening time varies from 2.5 to 4 seconds.
