CAME 8K01MI-0515, Быстрая настройка

Страница: 18 / 32

11 commissioning via panel
Ensure the wiring is complete (refer to the wiring diagram) & any required physical stops are set before
commencing with programming
Tick
1. Power on the control panel
2. Select your desired Language
3. Wizard – Confirm
YES
4. Set the number of motors
No. Motors
M1 + M2
5. Set the motor type
Motor type
FROG-E
CAUTION, Ensure the gate movement area is clear of all obstructions
6. Check the motor direction .
For motor 2, Press and hold
The gate should open, if not reverse the motor cables for motor 2 (Connections M2, N2)
Leave the gate leaf in the halfway position.
For motor 1, Press and hold
The gate should open, if not reverse the motor cables for motor 1 (Connections M1, N1)
Leave the gate leaf in the halfway position.
7. Disable all safety options
8. Add users
NO
9. Travel Calibration
YES
The Gates will now perform a close and open cycle.
10. Exit the programming using the button.
11. Check the gate operation by pulsing across connections 2 & 7, the gate will close.
Please refer to the main manual for:
Changing automatic closing time, adjusting encoder settings if required
Should the gates not operate as suggested above,
call CAME helpline 0115 921 0430 for technical support.
Safety inputs should now be configured and the gate force tested as required.
Please refer to the full manual to complete the commissioning.
if you prefer to commission your gates manually and not
take advantage of connect, please follow the steps below
button - used to perform the following operations:
• Exit the menu
• Delete the changes
• Go back to the previous screen
buttons - used to perform the following operations:
• Navigate the menu
• Increase or decrease values
button - used to perform the following operations
• Access menus
• Confirm a choice
1
2
3
ESC ENTER <>