CAME 8K01MI-0515, Быстрая настройка

Страница: 9 / 32

8 initial power ON
Power on the control board.
The display will read
to check motor direction using control panel
CAUTION, Ensure the gate movement area is clear of all obstructions
Check the motor direction
CONFIGURATION
-
MOTOR SETTINGS
-
MOTOR TEST
For motor 2, Press and hold =M2
The gate should open, if not reverse the motor cables for motor 2 (Connections M2, N2)
Leave the gate leaf in the halfway position.
For motor 1, Press and hold =M1
The gate should open, if not reverse the motor cables for motor 1 (Connections M1, N1)
Leave the gate leaf in the halfway position.
OUT1
OUT2
Keycode
123456789ABCDE F
MATR
54051 6
300mAE GSM – 900 33dBm
DCS – 1800 30dBm
869.5MHz 14dBm
24V
CONNECT
123 4
GND
A
N
T
10 +
2
COM
IN2
COM
IN1
B
A
–
1A 30V
RGSM001S
1 2
1
GSM LED (Blue)
After a few seconds the LED will flash 1x/sec
indicating the RGSM001S is registered on a
GSM network.
2
POWER LED (Green)
The LED will flash 5x/sec indicating the
RGSM001S is not yet configured on the
Connect platform.
antenna bracket
Fitting instructions
Make sure your kit
contains the antenna,
bracket and cable.
Remove the safety
screw from the cable.
Tighten the safety
screw until the cable is
secure.
Screw the bracket
into place using the
two holes. Do not
screw into the plastic
enclosure as this
will invalidate your
warranty.
Slot the cable into
the single hole of the
bracket and re-attach
the safety screw.
Screw the antenna into
place.
1 2 3 4 5 6
Installer Tip
If the RGSM001S is located
in a concealed area and a
low GSM signal observed,
please use the supplied cable
extension for the GSM aerial.
This then allows the aerial to
be located in a more suitable
position.