CAME 002ZL60, Руководство по установке

Страница: 25 / 64

1 2 3P 7 10 TS 2 C1 CX
TX 2 TX 2
10 2 TX C
-
+
-
NC
+ -
10 TS 2 C1 CX
10 TS 2 C1 CX
TX 2
TX 2
10 2 TX C
-
+
-
NC
+ -
p.
9
- M
an
u
al
FA
01
04
0-
EN
- 0
2
/2
0
1
8
- © C
A
M
E S
.p.
A
. - T
h
e c
onte
nts of th
is
m
an
u
al
m
ay b
e c
h
an
g
ed, at a
ny ti
m
e, a
n
d w
ith
ou
t n
oti
ce
.
Photocells
Configure contact C1 or CX (NC), input for safety devices such as photocells.
See functions programming of input C1 or CX in:
- C1 reopening while closing. While the gate leaves are closing, opening the
contact causes the inversion of movement until they are completely open;
- CX partial stop, gate leaves stop if they are moving, triggering the automatic
closing time; if the automatic closing time is enabled);
- CX obstruction wait, gate leaves stop is they are moving. They resume
movement once the obstruction is removed.
If unused, contacts CX and C1 should be deactivated during programming.
Photocells safety connection (services test)
Reopening during closing photocells connection (NC contact) see
functions programming.
Safety devices
Photocells connection (NC contact), see the functions programming
section.
⚠
Only program functions when the operator is stopped.
When programming is finished, set all Dip-switches to OFF.

You can save up to 25 users.

Use the Dip-switch to select the function if the LED is lit, the
function is enabled. Whereas if the LED is off, the function is
disabled.
PROG button
PRG LED
DIP-SWITCH
FUNCTIONS PROGRAMMING
Connecting the safety devices (i.e. the safety test)
At each opening and closing command, the control board checks the effi cacy of
the safety devices (such as, photocells).
Any anomalies will inhibit all commands.
Enable this function when programming.