Cambium Networks PMP 450, Конфигурация и руководство пользователя

Страница: 92 / 196

Task 5: Configuring security Chapter 2: Configuration and alignment
2-60
pmp-0050 (May 2012)
Deleting a User from Access to a Module
The Account => Delete User tab provides a drop-down list of configured users from which to select the user
you want to delete.
Figure 9 Delete User tab of the SM
Accounts that cannot be deleted are
the current user's own account.
the last remaining account of ADMINISTRATOR level.
Overriding Forgotten IP Addresses or Passwords on AP and SM
A small adjunctive product allows you to temporarily override some AP/SM settings and thereby regain control
of the module. This override plug is needed for access to the module in any of the following cases:
You have forgotten either
o
the IP address assigned to the module.
o
the password that provides access to the module.
The module has been locked by the No Remote Access feature.
You want local access to a module that has had the 802.3 link disabled in the Configuration page.
You can configure the module such that, when it senses the override plug, it responds by either
resetting the LAN1 IP address to 169.254.1.1, allowing access through the default configuration without
changing the configuration, whereupon you will be able to view and reset any non-default values as you
wish.
resetting all configurable parameters to their factory default values.
Acquiring the Override Plug
You can either purchase or fabricate an override plug as follows. To purchase an override plug for a nominal
fee, order the plug at
http://www.best-tronics.com/motorola.htm . To fabricate an override plug, perform the
following steps.
1
Install an RJ-11 6-pin connector onto a 6-inch length of CAT 5 cable
2 Pin out all 6-pins.
3
Short (solder together) Pins 4 and 6 on the other end. Do not connect any other wires to anything.