Calsense ET2000, Руководство по программированию

Страница: 16 / 26

16
Test (con’t)
To run a test cycle of all the stations on a program or all the stations on the controller, Press an ARROW Key to move the cursor
to the Test xxxx Stations setting. Press the PLUS or MINUS Key to select the desired Program or ALL stations (PROG B has
been selected in the example on the previous page), Press the TEST xxxx STATIONS Menu Key to start the test cycle. To end
the test cycle before all of the stations have completed the test, Press the STOP Key.
Master Valve
From the Manual Irrigation screen, Press the MASTER VALVE Menu Key, the Master Valve Override screen will appear (shown
below). At this screen the master valve can be opened or closed, depending on the type of master valve installed on the system,
for a selected amount of time between 1 hour and 24 hours. At the end of the selected time, the master valve override will end.
MASTER VALVE OVERRIDE
OPEN the MASTER VALVE for 8 HOURS
MANUAL SEQUENCE STATIONS & TIMES
Stations: 1 4 -- -- -- -- -- -- --
Minutes: 5 1 0 -- -- -- -- -- -- -- --
--
Stations: -- -- -- -- -- -- -- -- -- --
Minutes: -- -- -- -- -- -- -- -- -- --
Stations: -- -- -- -- -- -- -- -- -- --
Minutes: -- -- -- -- -- -- -- -- -- --
Stations: -- -- -- -- -- -- -- -- -- --
Minutes: -- -- -- -- -- -- -- -- -- --
(use BACK key when done)
MANUAL SPECIAL SEQUENCE
Start Times : OFF
Number of Cycles : 1
Schedule : --- --- --- --- --- --- ---
Run Until : Aug 15 2002, Thu
NOW
Set the STATIONS & TIMES
PRESS HERE TO RUN IT
( Detected a NOW start time )
Press the PLUS or MINUS Key to select the OPEN or CLOSE setting. Press an ARROW Key to move the cursor to the HOURS
setting, Press the PLUS or MINUS Key to set the desired number of hours of override. Press the xxxx MASTER VALVE FOR x
Menu Key to start the master valve override. To end the override before the set end time, Press the STOP Key.
Note : Scheduled irrigation will not occur while the master valve override is activated.
Manual Special Sequence
From the Manual Irrigation screen, Press the MANUAL SPECIAL SEQUENCE Menu Key, the Manual Special Sequence screen
will appear (shown below). If the Manual Special Sequence has never been programmed it will appear with the default settings
shown below (the date will be the current date).
To manually start a sequence the Start Time setting will be set to NOW (as shown in the example above), Press the SET STATIONS
& TIMES Menu Key, the Manual Sequence Stations & Times screen will appear (shown below).
Using the PLUS or MINUS Key and the ARROW Keys, set the desired stations and run times for manual operation. In the example
above station 1 has been set with a run time of 5 minutes and station 4 has been set with a run time of 10 minutes. After all
stations have been set, Press the
BACK Key to return to the Manual Special Sequence screen, then Press the PRESS TO RUN
IT Menu Key to start the manual sequence. To end the manual sequence before all stations have finished, Press the STOP Key.