Caloric CSG3601, Руководство пользователя

Страница: 14 / 56

14
Correct
Not centered Too small Too large
Burner Caps
Test and Adjust Surface Burner Flame
WARNING
!
To avoid electric shock that can cause personal
injury or death, disconnect main electrical supply to
range before servicing.
Turn on burner. See Operating Surface Burners section for
burner operating instructions. Surface burner should ignite
within 4 seconds. Properly adjusted surface burner flames
are clean and blue with a distinct inner cone
approximately ¼ inch to ½ inch long. Some yellow flame
is normal when burning LP/Propane. See
Adjusting Air
Shutter section.
• If burner flame is blowing or noisy, reduce airflow to
burner by closing air shutter
• If burner flame does not hold its shape, increase airflow
to burner by opening air shutter.
A
Burner
A—¼ inch to ½ inch long
Surface Burner Flame
Burner Installation
(cont’d)
Place Range
Plug in range. Slide range into place. Connect gas supply
as needed. Carefully level range using legs provided.
Range must be level to cook and bake uniformly.
• Place a level on top oven rack or on top of range when
leveling.
• Leveling legs must be extended out ¼ inch to engage
anti-tip bracket.
Removal and Reinstallation of Range
1. Unplug range cord.
2. Turn off gas valve and disconnect gas supply.
3. Remove range and place aside.
4. Remove anti-tip bracket and re-install anti-tip bracket
into new location using instructions provided with
bracket.
5. To re-install range, follow instructions in Installation
section of this manual.
• Do not reuse a flexible connector after moving
appliance.
Place Grates and Burner Caps
Place burner cap on burner base and grate on rangetop.
A
B
C
A—Burner grate
B—Burner cap
C—Burner base
Place Grates and Burner Caps
Pegs in the burner base fit into recess in underside of
burner cap. To make sure cap is properly aligned and
leveled, move burner cap around on burner base. Burner
cap must be correctly seated on burner base for proper
operation of burner.
Make sure proper cap size is on each burner base.
Burner does not burn properly if wrong size burner cap is
placed on burner base.
Turn on burners to check for proper operation. See
Operating Surface Burners section for burner operating
instructions.