Caloric CSG3601, Руководство пользователя

Страница: 10 / 56

10
Converting Surface Burners for Use with LP/Propane
1.
Remove (pull off) all (5) burner control knobs from
range.
• Exposes 2 screws on burner control panel.
2. Remove 2 screws from burner control panel.
• Panel drops slightly after screws are removed.
3. Grasp bottom of burner control panel, gently lift and
pull out panel until clear of burner valve stems.
• After burner
control panel
clears valve
stems, continue to
roll panel until free
from range. Set
aside. See
Pivot
Point in figure.
• Gas valve and
orifice hood are
visible after burner
control panel is
removed.
A—Burner Control Knob
B—Pivot Point
C—Burner Control Panel
D—Screw
Burner Control Panel
4. While facing range front, turn orifice hoods
counterclockwise 1½ to 2 turns or until snug.
• Use ½ inch open end or 90° offset open end
wrench.
• Do not over tighten orifice hoods. If orifice hoods are
over tightened, gas supply can be cutoff or orifice
hoods can strip.
5. Open air shutter fully.
A—Orifice Hood
B—Air Shutter
Converting Surface Burners for Use with LP/Propane
6. Reassemble burner control panel after adjusting air
shutter.
• See
Adjusting Surface Burner Flame section.
Converting for Use With LP/Propane
(cont’d)
Converting Oven Burner for Use with LP/Propane
1.
Open broiler door and remove broiler rack, pan, and
grid.
2. Through rectangular hole on rear of broiler cavity, turn
orifice hood (tighten), clockwise when facing front of
range, 1½ to 2 turns or until snug. Use ½ inch open
end wrench.
• Do not overtighten orifice hood. Orifice hood can
strip.
3. Loosen air shutter lock screw and open air shutter
fully.
• Tighten air shutter lock screw after adjusting.
A—Air Shutter
Screw
B—Orifice Hood
C—Air Shutter
Converting Oven Burner
Converting Oven Thermostat for Use with
LP/Propane
1.
Remove (pull off) all (5) control knobs from range.
• Exposes 2 screws on burner control panel.
2. Remove 2 screws from burner control panel.
• Panel drops slightly after screws are removed.
3. Grasp bottom of burner control panel, gently lift and
pull out panel until clear of burner valve stems.
• After burner control panel clears valve stems,
continue to roll panel until free from range. Set
aside.
4. Turn the selector screw on oven thermostat so the
pointer is towards “LP”.
5. Reverse steps 1–3 to replace control panel and
knobs.
Converting Oven Thermostat
A
B
C
D
A
B
Open Fully
Selector Screw
LP N
OFF
LP N
OFF
LP N
OFF
A
B
C
Open
Fully