Caloric CSG3601, Руководство пользователя

Страница: 11 / 56

11
Converting for Use with Natural Gas
Converting Surface Burners for Use with
Natural Gas
1.
Remove (pull off) all (5) control knobs from range.
• Exposes 2 screws on burner control panel.
2. Remove 2 screws from burner control panel.
• Panel drops slightly after screws are removed.
3. Grasp bottom of burner control panel, gently lift and
pull out panel until clear of burner valve stems.
• After burner control panel clears valve stems,
continue to roll panel until free from range. Set
aside.
• Gas valve and orifice hood are visible after burner
control panel are removed.
4. While facing range front, turn orifice hoods clockwise
1½ to 2 turns.
• Use ½ inch open end or 90° offset open end
wrench.
5. Close air shutter to approximately
3
/
8
inch.
Converting Oven Burner for Use with Natural Gas
1.
Open broiler door and remove broiler rack, pan, and
grid.
2. Turn orifice hood counterclockwise (loosen) 2 full
turns using ½ inch open end wrench.
3. Close air shutter to approximately
3
/
8
inch.
4. Replace broiler door.
Converting Oven Thermostat for Use with Natural
Gas
1.
Remove (pull off) all (5) control knobs from range.
• Exposes 2 screws on burner control panel.
2. Remove 2 screws from burner control panel.
• Panel drops slightly after screws are removed.
3. Grasp bottom of burner control panel, gently lift and
pull out panel until clear of burner valve stems.
• After burner control panel clears valve stems,
continue to roll panel until free from range. Set
aside.
4. Turn the selector screw so the pointer is towards “N”.
5. Reverse steps 1-3 to replace control panel and
knobs.
Converting Type 1 Pressure Regulator for Use with
Natural Gas
1.
Remove pressure regulator cap with a wrench.
2. Remove plastic insert from pressure regulator cap.
• Plastic insert fits tightly in cap.
3. Reverse plastic insert and carefully push plastic insert
firmly into hole in pressure regulator cap.
• Insert must show “NAT” or be blank.
4. Place pressure regulator cap on pressure regulator
and tighten.
• Insert should not disturb spring in body of regulator.
Converting Type 2 Pressure Regulator for Use with
Natural Gas
1.
Remove pressure regulator cap with a wrench.
2. Reverse pressure regulator cap.
• Insert shows “NAT” or is blank.
3. Place pressure regulator cap on pressure regulator
and tighten.