![background image](http://html1.mh-extra.com/html/california-instruments/bps-series/bps-series_user-manual_3435496138.webp)
User Manual
AMETEK Programmable Power
BPS Series
138
Power up the AC source using its on/off switch. A message will appear on the LCD once the power comes
on:
Please wait…
After about 30 seconds, this message changes to:
Loading Program…
When
this “Loading Program…” message appears on the LCD of the BPS front panel,
press the ENTER
key on the keypad of the BPS unit once
. If you wait too long, you may have missed the window and you
will have to recycle power on the AC source and try again.
This will put the source controller into the Flash down load mode. Wait until the screen shown below
appears. This screen shows the RS232 setup parameters that are used in the boot loader mode.
Firmware Down Load Mode
User Entry
Serial Port Setup
Baud 38400,Bits 8,Stop 1,No Parity
Now launch the Flash Loader utility program “FlashLoaderComm.exe”.
Select the COM port to be used (default is COM1). Leave “Baud rate” and “Cmd Delay” set to their
default values of 38400 baud and 0 msec.
Содержание BPS Series
