CalAmp SMC-CDMA Series, Руководство пользователя

Страница: 35 / 62

001-0004-819 Rev01
Page 35 of 62
S
S
E
E
C
C
T
T
I
I
O
O
N
N
1
1
0
0
-
-
A
A
T
T
C
C
O
O
M
M
M
M
A
A
N
N
D
D
R
R
E
E
F
F
E
E
R
R
E
E
N
N
C
C
E
E
All modem functions are controlled using the same industry-standard AT commands that are used to
control landline modems. A knowledge of all these commands is not required by most users, but are
provided here as a reference.
AT Command Types
There are several types of AT commands as defined in the following list;
Modem ID Commands
Hardware Information Commands
Modem Configuration, Profile, & InterfaceCommands
PRL and PRI Commands
Enhanced AT Commands
Call Control Commands
Short Message Service (SMS) Commands
Network Related & User Interface Commands
TCP/UDP IP Commands
FTP (File Transfer Protocol) Commands
GPS – LBS Commands
FOTA (Firmware update Over The Air) Commands
The parameters set by the various AT commands in this section are applied to all subsequent calls
and will be used each time you place a call. As such, your custom settings (if not saved in a profile)
will be available until you power down the modem. These settings are lost upon powerdown
if not saved. For further information, refer to the Motorola C24 AT Command Set
[1] document.
Command Line Syntax
The "AT" or "at" prefix must be set at the beginning of each command line. To terminate a command
line enter <CR>.
Commands are usually followed by a response or, result codes, that includes
"<CR><LF><response><CR><LF>".
Table: 10.1 Command Syntax
AT command type Syntax Function
Test command AT+XXX=?
The mobile equipment returns the list of parameters
and value ranges set with the corresponding Write
command or by internal processes.
Read command AT+XXX?
This command returns the currently set value of the
parameter or parameters.
Write command AT+XXX=<...> This command sets user-definable parameter values.
Exec(ution)
command
AT+XXX
The execution command reads non-variable
parameters determined by internal processes in the
GSM engine.
Commands may be edited using the backspace key, but the backspace will not delete the AT
attention command at the beginning of the command line.