14
31-2000815 Rev. 0
Installation
10
LEVEL THE RANGE
WARNING
The range must be level and be
supported by the legs—not the wheels . The range could
move if the wheels make contact with the floor . Be sure
all legs make contact with the floor in any installation .
■ All legs must be leveled after the product is installed.
■ Check to be sure the adjoining cabinets/countertops
are level, front to back and left to right across the
opening of the range .
■
Measure the distance from the floor to the top of the
countertop in the left and right rear corners .
■
Adjust the height of the range to countertop height
or higher .
IMPORTANT:
This range should always be installed
at countertop height or higher . DO NOT INSTALL THE
RANGE LOWER THAN ADJACENT COUNTERTOP
HEIGHT. The range must be supported by all 4 legs,
regardless of countertop height .
FRONT LEG ADJUSTMENT
■ A leveling leg wrench is supplied. Reach under the
front of the range near the right leg . Locate and
remove a thumb screw, then slide wrench out of
the slot .
■ Slide front cylinders up to access front leveling legs.
Be careful not to damage cylinder .
■ Use the supplied wrench to adjust the front leveling
legs. Turn clockwise to extend the legs to lift and
stabilize the range . Turn counterclockwise to retract
the legs and allow the range to rest on its rollers .
■ Be sure to return the wrench to its storage slot for
future use .
10
LEVEL THE RANGE (cont.)
REAR LEG ADJUSTMENT
WARNING
To reduce the risk of fire or electric
shock, always replace the spill plugs in the leveling
rod holes .
■
Remove two screws from rear vent trim . Slide vent
trim forward, then lift up to remove.
■
Remove the 2 spill plugs to locate the rear leg
extension leveling rods. Use a 1/4” driver or socket
wrench to adjust the left or right rear legs .
■ Find the two rear leg extension rods. Use a 1/4” driver
or wrench to adjust the left or right rear legs .
■
Replace the 2 spill plugs and then replace the rear
vent trim using the original screws .
Slide leg
cylinder up .
Thumb Screw
11
REPLACE OVEN DOOR(S)
Skip this step if oven doors are in place.
I
MPORTANT:
Do not lift the door by the handle .
To replace the oven doors:
■
Firmly grasp the door
at the top sides. This is critical.
■ Approach the range with the door angled in a
vertical position .
■ Guide the hinges into the slots.
■ Push the door in firmly while opening.
■ Once in position, open the door completely. Push
the hinge locks back in toward the front frame .
CAUTION
Take care when replacing the oven
doors . If the hinge latch
is not securely locked,
the hinge may snap back
and separate . If the hinge
separates, you must apply
pressure (possibly with
your foot) to press it back
together and then engage
the hinge latch .
Spill Plugs
Rear Leg
Extension
Rods