Cadel SATURNO 16, Руководство по установке

Страница: 33 / 44

33
SATURNO
All these operations must be planned in time with your Autorized Technical Assistance Service.
• After a long ineffective time, before turning on the stove check if there are obstructions in the fume exhaust.
• If the stove had been using continuously and intensely, the whole system (chimney included), must be cleaned and checked
more frequently.
• In case of replacement of damaged pieces please ask for the original spare part at the Autorized Retailer.
17.2 PERIODIC CLEANING PERFORMED BY A QUALIFIED TECHNICIAN "SATURNO"
EXTRACTING THE PRODUCT
To perform maintenance of some devices and cleaning of certain parts, it is necessary to extract a part of the product from its
housing. The movable part is fitted on sliding guides, which promote the handling process. Before extracting it, release the handle
lock following the instructions in this manual. The guides are fitted with end-of-travel devices that block the movable part when
fully extracted.
ATTENTION: THE PRODUCT MUST ONLY BE EXTRACTED WHEN THE STRUCTURE IS COLD. All cleaning and/or
replacement of parts must be carried out with the electric plug disconnected. Disconnect the product from the
230V power supply before performing any maintenance operations.
To extract the movable part, follow the instructions in part 1 of the manual. It is important to use the support
supplied to sustain the product’s weight.
When the movable part is put back in place, make sure the machine is locked to the fixed part by closing the screws
(see manual part 1). Forgetting to do so may result in the product not working due to leaking soot.
It is also advisable to vacuum near to the coupling “r” and “k” and remove and clean the smoke fan “L”.
After cleaning as described above and before reassembling all the parts, it is advisable to vacuum the ash pan and brazier zone.
Then thoroughly clean the lower exchanger, replace any gaskets if needed, and reassemble.
17.3 PIPE UNIT CLEANING
For better performance of the boiler, the pipes inside the combustion chamber should be cleaned once a month.
Open the firebox door and use the brush provided to clean the pipes at the top inside the combustion chamber. Brush the pipes
several times so that the ash deposited inside them falls to the bottom around the brazier.
Use a vacuum cleaner to remove all fallen material.