CAC / BDP 8kW, Руководство пользователя

Страница: 97 / 116

1
These Installation Guidelines are designed to famil-
iarize personnel with the installation process for the
battery charger required for the air-cooled generator
only. It does not replace or supersede any information
contained in any of the written documents shipped
with the unit. This booklet should only be used in
conjunction with the Owner’s Manual, Installation
Guide and other technical documents shipped with
the unit.
Future product updates and/or modifications will be
reflected in the written documentation included with
the equipment. Always read all accompanying docu-
mentation carefully before attempting to install any
generator, transfer switch or related equipment.
NOTE:
It is essential to comply with all regulations estab-
lished by the Occupational Safety and Health
Administration (OSHA) and strict adherence to all
local, state and national codes is mandatory.
This device should be installed with all local
electrical codes and/or the latest edition of the
National Electrical Code. All wiring must be the
correct size and type, and must conform to local
codes, standards, and regulations.
1.2 BATTERY CHARGER
COMPATIBILITY
This battery charger is compatible, and required with
all 2008 model line Air-cooled Standby Generators.
For all generators that were supplied with a transfer
switch/load center, the charger is already installed in
the transfer switch enclosure and this charger is not
needed. For all generators that were NOT supplied
with a transfer switch/load center, the charger is NOT
already installed and MUST be installed according to
these guidelines.
1.2.1 DETERMINATION OF GENERATOR/
‹
TRANSFER SWITCH MODEL TYPE
The Battery charger included with this manual only
needs to be used with certain transfer switch configu-
rations. Some transfer switch configurations already
have the battery charger installed in the transfer
switch. Before proceeding it is necessary to select the
transfer switch used from the following table.
Section 1 — General Information
Battery Charger Installation Guidelines
Switch Type Switch Description Notes Proceed to Section
RTSD
Pre-wire with 8 circuit load
center
Battery charger is included and pre-wired with
the transfer switch. Discard this charger. No
further installation is required
Stop Here
RTSF
ST100R10C
Pre-wire with 10 circuit
load center
Battery charger is included and pre-wired with
the transfer switch. Discard this charger. No
further installation is required
Stop Here
RTSH
Pre-wire with 12 circuit
load center
Battery charger is included and pre-wired with
the transfer switch. Discard this charger. No
further installation is required
Stop Here
RTSP
ST100R14C
Pre-wire with 14 circuit
load center
Battery charger is included and pre-wired with
the transfer switch. Discard this charger. No
further installation is required
Stop Here
RTSW
ST100R16C
KGATX0216100
Pre-wire with 16 circuit
load center
Battery charger is included and pre-wired with
the transfer switch. Discard this charger. No
further installation is required
Stop Here
RTSS
KGALT0101200
SR200RDPM
Power Manager LTS - Load
Shed with 16 circuit load
center
Battery charger is included with the transfer
switch. Proceed with connections.
2
RTSN
SRXXXR
KGATX
Standard
The included battery charger must be installed
and connected
3
RTSE
SRXXXRD
KGATD
Service Entrance Rated
The included battery charger must be installed
and connected
3
005448-0
005449-0
KGATD0101RSP
GenReady
The included battery charger must be installed
and connected
4
NOTE: Switch Type is the first four (4) digits of the model number and can be found on the data label inside the switch.