Cabletron Systems Netlink FRX4000, Руководство пользователя

Страница: 108 / 426

8-2 FRX4000/FRX6000 4.0 User Guide, Rev 01
Required Configuration
To run a physical port as X.25, make sure the following are properly configured:
●
Node parameters , which is general configuration that must be done no matter
which protocols will be run in the node. See Chapter 4.
●
RLPs that will contain the interface(s) to the user device(s), network, and/or
X.25 PVC, plus Line Interface Card(s) supporting the ports that will be the inter-
faces. See Chapter 5.
●
Protocol(s) : X.25 and any others that will be transmitted over the network. See
Chapter 5.
●
X.25 port(s) (see below) that will connect to the user device(s), network, and/or
PVC(s).
●
Subscriber ID(s) (page 8-21), which identifiy user devices to each other and the
FRX4000/6000.
Before configuring a logical X.25 port, make sure these are properly configured:
●
Protocol(s) that will be transmitted over the logical port. See Chapter 5.
●
Physical frame relay port on which the logical port will reside. See Chapter 6
and Chapter 7.
Configuring a Physical X.25 Port
Once the necessary Node ( Chapter 4 ), RLP ( Chapter 5 ), and Protocol ( Chapter 5 )
parameters have been configured, press
[A]
at the Port Configuration Menu (or
[A], [C],
[A]
from the Main Menu. When prompted, enter:
●
(FRX6000 only) RLP containing the port:
0–7
. (The default is
0
.)
( RLP numbers are described in Chapter 5.)
●
Port (see port locations in Chapter 6):
0–7
. (The default is
0
.)
The display for an existing port will show the configured parameter values, while the
display for a new port will show default database values (listed in tables on
page 8-6
and page 8-13 .) The following figure is an example of an existing port.