CSX7000 Guide
66 CyberSWITCH
1.
Connect, the J1 34-pin header, flexible diskette drive, to the MUX flexible-diskette connector for
slot "x" of the processor board. Refer to the following chart:
2.
Connect J2 40-pin header, IDE hard disk drive, to the PM hard disk I/O cable.
3.
Connect J3 26-pin header, BC I/O, to the MUX BC I/O connector for slot “x” of the processor
board. Refer to chart, step 1.
S
OFTWARE
S
ETUP
Software setup includes a three-step process:
•
Processor Module CMOS setup
•
hard disk drive initialization (PM)
•
software initialization (PM)
CMOS S
ETUP
CMOS must be configured for proper operation of the CSX7000. Default values may be accepted
for all except the following parameters:
Slot #
Group
Power
Connection
#
MUX flexible-diskette
Connector
MUX BC I/O Connector
1 or 2
1
between J27 and J11
J11
3 or 4
2
between J26 and J19
J19
5 or 6
3
between J25 and J18
J18
7 or 8
4
between J24 and J17
J17
9 or 10
5
between J23 and J16
J16
11 or 12
6
between J22 and J15
J15
13 or 14
7
between J21 and J14
J14
15 or 16
8
between J20 and J13
J13
CMOS setup section
BIOS parameter
CSX7000 Setting
Standard Setup
date and time
Master Disk
set correct date and time; provide
type and disk parameters
Advanced Setup
mouse support
disabled
Chipset Setup
onboard PCI ethernet
disabled
Peripheral Setup
serial port 2
parallel port
disabled
disabled
