CSX7000 Guide
26 CyberSWITCH
R
EMOTE
C
ONSOLE
C
ONNECTION
To support a remote SNMP administration console, connect the CSX7000 to the Local Area
Network (LAN) via the LAN connector on the EMS processor board. Note that this is a 10-Base T
connection.
C
ONNECTIONS
FOR
S
YSTEM
M
ONITORING
In order for the EMS to properly operate, you must set up the EMS bus (or data highway) to provide
connection from the IES of each subsystem to the EMS processor. With a single CSX7000, there is
no daisy-chained data highway. Yet the subsystem’s IES must still be connected to the EMS
processor. To make this connection, perform the following:
•
Connect the two RJ-11 connectors labeled IES OUT and IES SUPERVISOR IN (on the rear pan-
el), using the IES-compatible cable supplied with the CSX7000. (The cable is marked.)
•
Terminate the highway by properly setting switch 1 (under the IES IN/OUT connectors) to
ON
. The switch is ON when it is pointing to the left when viewed from the rear panel. Switch
2 is not used.
P
OWER
S
UPPLY
C
ONNECTIONS
The CSX7000 has two separate power supplies to provide fault tolerance in the event of a single
power failure. For the utmost protection, connect each of the two supplies (labeled PS1 and PS2 on
the rear panel) to a different AC power source.
To help prevent accidental disconnection, we provide a
strain relief bar for each dual power cord
pair. (This
strain relief bar
ships with the power cords preattached.) To install, remove the screws to
the immediate right of the AC power outlets on the back panel of the CSX7000. Align strain relief
bar with the exposed holes, and attach bar with screws. Then plug attached power cords into unit.
CAUTION: 1 MINUTE
POWER OFF REQUIRED
I
N
O
U
T
I
E
S
V
I
D
E
O
O
U
T
V
I
D
E
O
I
N
ERS / FT
IES SUPERVISOR
IN OUT
Power
Install power cord
strain relief here
Strain Relief Bar
for power cords
