Cabletron Systems 6SSRM-02, Инструкция по установке и эксплуатации, Страница: 55 / 74

Setting Up Passwords
Software Installation and Setup 3-9
7. After verifying the SNMP configuration, save the changes to the Startup configuration file by
entering the copy active to startup command.
Remember to enter yes or y when the CLI asks you whether you want to overwrite the Startup
configuration.
Setting Up Passwords
You can password protect CLI access to the 6SSRM-02 by setting up passwords for login access
and Enable access. Users who have a login password but not an Enable password can use only the
commands available in User mode. Users with an Enable password can use the commands
available in Enable and Configure modes as well as the commands in User mode.
In addition, you can set up the 6SSRM-02 for TACACS and/or RADIUS authentication on login
and password by a TACACS or RADIUS server. You can find a section describing configuration
of the 6SSRM-02 for TACACS and RADIUS in the SmartSwitch Router User Reference Manual.
Note: If a password is configured for Enable mode, the 6SSRM-02 prompts you for the password
when you enter the enable command. Otherwise, the 6SSRM-02 displays a message
advising you to configure an Enable password before entering Enable mode. From Enable
mode, you can access Configure mode to make configuration changes.
The default password for each access level is blank. (Simply press Enter or Return without
entering a password.) If you want to add password protection to the CLI, use the following
procedure.
1. Ensure that you are in Enable mode by entering the enable command in the CLI.
2. Ensure that you are in Configure mode by entering the configure command in the CLI.
3. Use the following command for each password you want to set:
4. Enter the show command to examine the changes accumulated in the scratchpad.
5. Enter the save active command to activate the commands.
6. Enter the system show active-config command to verify the active changes.
system set password login|enable
<string>
|none