Cabletron Systems 6SSRM-02, Инструкция по установке и эксплуатации, Страница: 43 / 74

Installing the Module into the 6C105 Chassis
Installation 2-3
Installing the Module into the 6C105 Chassis
Caution:
Failure to observe static safety precautions could cause damage to the 6SSRM-02.
Follow static safety handling rules and wear the antistatic wrist strap provided with the 6C105
chassis.
Do not cut the non-conductive bag to remove the module. Sharp objects contacting the board or
components can cause damage.
The 6SSRM-02 can be installed in any of the slots that are available. To install a module, refer to
Figure 2-1 and proceed as follows:
1. Remove the blank panel covering the slot in which the module will be installed. All other slots
must remain covered to ensure proper airflow and cooling. (Save the blank plate in the event
you need to remove the module.)
2. Carefully remove the module from the shipping box. (Save the box and packing materials in
the event the module must be reshipped.)
3. Locate the antistatic wrist strap shipped with the 6SSRM-02. Attach the antistatic wrist strap to
your wrist and plug the cable from the antistatic wrist strap into the ESD grounding receptacle
at the upper right corner of the 6C105.
4. Remove the module from the plastic bag. (Save the bag in the event the module must be
reshipped.) Observe all precautions to prevent damage from Electrostatic Discharge (ESD).