Cabletron Systems 6SSRM-02, Инструкция по установке и эксплуатации, Страница: 49 / 74

Starting the Command Line Interface
Software Installation and Setup 3-3
Note:
The command prompt will show the name of the 6SSRM-02 in front of the mode
character(s). The default name is “ssr”. The procedure in
“Setting Basic System
Information” on page 3-4 describes how to change the system name.
When you are in Configure or Enable mode, use the exit command or press Ctrl+Z to exit to the
previous access mode.
Note:
When you exit Configure mode, the CLI will ask you whether you want to activate the
configuration commands you have issued. If you enter yes or y, the configuration
commands you issued are placed into effect and the 6SSRM-02’s configuration is
changed accordingly. However, the changes are not written to the Startup configuration file
in the 6SSRM-02’s boot flash and therefore are not reinstated after a reboot. See
“Activating Configuration Changes and Saving the Configuration File” on page 3-17 for
information about saving configuration changes.
Basic Line Editing Commands
The CLI supports EMACs-like line editing commands. The following table lists some commonly
used commands. For a complete set of commands, see the SmartSwitch Router User Reference
Manual.
Table 3-1 Some commonly used CLI commands
Key sequence Command
Ctrl+A Move cursor to beginning of line
Ctrl+B Move cursor back one character
Ctrl+D Delete character
Ctrl+E Move cursor to end of line
Ctrl+F Move cursor forward one character
Ctrl+N Scroll to next command in command history (use the cli show
history command to display the history)
Ctrl+P Scroll to previous command in command history
Ctrl+U Erase entire line
Ctrl+X Erase from cursor to end of line
Ctrl+Z Exit current access mode to previous access mode