Cabletron Systems 6SSRM-02, Инструкция по установке и эксплуатации, Страница: 51 / 74

Setting Basic System Information
Software Installation and Setup 3-5
Here is an example:
5. Use the interface add ip command to set the IP address and netmask for the en0 Ethernet
interface, as shown in the following example::
Note:
The en0 interface is automatically created by the system and is reserved for the
6SSRM-02’s management port.
6. To show the changes accumulated in the scratchpad, enter the show command while in
Configure mode, as shown in the following example:
When you enter commands in Configure mode, the 6SSRM-02 does not immediately execute
the commands. Instead, the 6SSRM-02 checks the syntax of the commands and if they are
syntactically correct, stores them in a temporary scratchpad in memory. The scratchpad is
automatically cleared when you log out of the SmartSwitch, so you must activate the changes
and then save them to the Startup configuration file to retain the changes, as explained below.
The scratchpad allows you to make configuration changes without worrying about the order
in which you issue the commands. Also, if you change your mind about configuration changes
you are making, you do not need to incrementally back out of the changes. You can simply
choose not to activate them. As you become more familiar with the 6SSRM-02 and the CLI and
begin to make detailed configuration changes, you may find the scratchpad quite useful. For
simple changes such as the ones in this procedure, you might instead want to activate the
changes as you go, then use CLI commands to view the results of the changes.
7. Enter the save active command to activate commands, such as the “system set...” commands
you used in
Step 4 , in the scratchpad.
ssr(config)# system set name "ctron-ssr-1"
ssr(config)# system set location "Sunnyvale, CA"
ssr(config)# system set contact "John Smith"
ssr(config)# interface add ip en0 address-netmask 10.50.11.22/16
ssr(config)# show
-EDIT-I-NOCONFIG, the running system has no configuration
******** Non-committed changes in Scratchpad ********
1*: system set name "ctron-ssr-1"
2*: system set location "Sunnyvale, CA"
3*: system set contact "John Smith"