Page 38
Model 256/PC Instruction Manual
SETTING BAUD RATE
The Model 256/PC has two baud rate settings: 1200 and 9600. The 1200 baud rate is used for
printing. The 9600 baud rate is used when interfacing the serial port to a PC. Set Baud Rate
must first be enabled by the ENABLE jack on the rear panel. To initiate and use Set Baud Rate,
proceed as follows:
1. Engage ENABLE jack on the rear panel.
2. Press Up or Down arrow to step through the menu until SET BAUD RATE is displayed.
3. Press MENU RUN key to initiate the mode. The display will show one of the following
as the current setting:
Baud Rate 1200 or
Baud Rate 9600
4. To change the baud rate, press the Up or Down arrow. The baud rate will change
between 1200 and 9600 each time an arrow key is pressed.
5. Press MENU RUN or RESET when the desired baud rate is displayed. The display will
show:
Completed
Содержание 256/PC
