Cablescan 256/PC, Инструкция по эксплуатации

Страница: 24 / 68

Page 16 Model 256/PC Instruction Manual
Cablescan
PROGRAM CODE
1
2
3
4
5
6
7
8
TOP
__________________
__________________
POWER OFF BEFORE REMOVING
PROGRAM CODE
9
10
11
12
13
14
15
16
P/N 5210943
USE ERASABLE MARKER
FOR RECORDING PROGRAM
NUMBERS. BE SURE TO
UPDATE OR VERIFY LABEL
AT EACH LOAD OR SAVE.
Figure 13. Program Cartridge Label Format
POWER TURN-ON AND SELF TEST
Verify that the power cord is connected to the proper power source as described under the initial
hookup, then proceed as follows:
NOTE
To change the power setting, refer to "Changing Power Setting."
1. Turn power on at the unit by moving the power switch on the rear panel to ON; the
display will light up and the tone will sound.
2. For self test of the basic Model 256/PC, verify that no circuits are connected to the
interface connectors on the rear panel.
3. Press the up or down arrow to step through the menu to reach SELF TEST.
4. Press MENU RUN to initiate Self Test. If the unit passes its self test, the display will
show Self Test Passed, and tone will sound; if it fails, the display will show one of the
following:
O for open plus the internal connector pin number.
S for short plus the internal connector pin numbers.
5. The self test will stop if a fault or error is encountered. To resume the test, press MENU
RUN again.