cabinaid Pro, Руководство по установке

Страница: 3 / 11

Installation of the Cabinaid Pro AED cabinet
Step 1: Remove the Cabinaid from the packaging and remove the lid from the cup. You can do
this by pulling the red handle and applying pressure to the ear.
Step 2: Remove the climate control unit from the bottom of the Cabinaid Pro and put it aside
for now. The climate control unit is not fastened or connected yet.
You should now have an empty cup with only the hanging bracket to install to a wall.
Step 3: Place your Cabinaid AED cabinet in the correct position against the wall. Use a marker
to indicate the location of the 3 boreholes. Please use the image below as reference for the
locations of the holes and the correct orientation.
The red marked holes are for wall screws and black circle is location of the hole for the power
supply cable.
Step 4: After marking the holes put the
Cabinaid storage compartment aside and use
a drill to make the holes in the wall.
For the red Mark holes:
Use a 6MM drill bit
For the black marked Power supply hole:
use a 14 MM drill bit
If applicable, place the wall plugs in the drilled
screw holes.
Step 5: After drilling the holes, run the power supply cable through the wall. Make sure the
cable length can be adjusted by gently pulling the cable. For installation to the climate control
unit about 10cm of cable should be outside. Please use the image on the left as a reference.