CAB 1-10010, Руководство пользователя

Страница: 14 / 16

23
EN
9) DIAGNOSTICS
PHOT
SWC1
STOP
SWO1 SWO2
SWC2
PHOT-C DAS
P.P. PED OPEN CLOSE
One segment of the display is linked to each input. In the event of failure it switches on according
to the following scheme.
N.C. inputs are represented by the vertical segments. N.O. inputs are represented by the horizontal
segments.
The control unit sees the message AMP1 or AMP2 in case of anti-crushing ammeter sensor inter-
vention.
10) ERROR MESSAGES
Some messages that are displayed in case of function anomalies are listed as follows:
Amp1 Obstacle error motor 1/anti-crushing Check presence of obstacles on motor 1 leaf run
Amp2 Obstacle error motor 2/anti-crushing Check presence of obstacles on motor 2 leaf run
ENC1
Error, encoder 1/detection of the obstacle
Check the correct connection of motor 1 encoder to the control unit, that no obstacles
are present along the gate stoke and the encoder operates correctly.
ENC2
Error, encoder 2/detection of the obstacle
Check the correct connection of motor 2 encoder to the control unit, that no obstacles
are present along the gate stoke and the encoder operates correctly.
Err1 Motor 1 circuit checking error Check motor 1 connections
Err2 Motor 2 circuit checking error Check motor 2 connections
Err3
error/fault power circuit Request technical assistance and eventually replace control unit.
Err4
PHOTA photocell checking error Check connections, PHOT A photocell alignment or presence of obstacles.
Err5 PHOTC photocell checking error Check connections, PHOTC photocell alignment or presence of obstacles.
Err6 Error edge active (during autoset) In autoset phase, the safety edge has intervened.
Err7
Error active stop (during autoset) In autoset phase, the STOP input has intervened.
Err8
Error active input (during autoset) In autoset phase a PP/Open/Close input has intervened.
thm1 Motor 1 thermal protection intervention
Wait for motor M1 cooling, in case reset does not take place, motor replacement may
be necessary
thm2
Motor 2 thermal protection intervention
Wait for motor M2 cooling, in case reset does not take place, motor replacement may
be necessary
COM1
Motor 1 communication error
Only for HD.3524 and HD.5024 motors: Communication error between motor Encoder
and central unit, check Motor 1 Encoder connections
COM2 Motor 2 communication error
Only for HD.3524 and HD.5024 motors: Communication error between motor Encoder
and central unit, check Motor 2 Encoder connections
BAR Activating BAR input BAR input has detected an obstacle.