C-COR Optiworx HW Series, Руководство по процедурам, Страница: 20 / 36

PN 060914-000
Revision C, October 2001
Page 2-6
© 2001, C-COR.net Corporation
DLP-500
Page 1 of 1
UNPACK EQUIPMENT AND INSPECT FOR DAMAGE
Summary: Open and inspect shipping boxes. Verify that all parts have been received, and that no
shipping damage has occurred.
1. Obtain the following tools and equipment to unpack the equipment:
• ESD wrist strap
• ESD antistatic mat
• Box cutter
Caution: Electronic equipment can be damaged by static electrical discharge. When
handling equipment units, always follow Electrostatic Discharge (ESD) protection
practices. Wear a grounded wrist strap when you touch a unit. Use antistatic
packaging when transporting or storing units. When working on a unit, always place
it on an approved, electrically grounded, antistatic mat.
2. Place the ESD wrist strap on your wrist and snap the ground wire to the wrist strap
connection. Plug the ground plug into a grounded ESD jack.
3. Examine the outside of the shipping carton for tears, dents, punctures, etc., that could
indicate possible shipping damage. If shipping damage is found, refer to “Contacting C-
COR.net Technical Support” on page v of this document for further instructions on how to
proceed.
4. Open the shipping cartons and carefully unpack the equipment. Do not discard the packing
materials at this time.
5. Check each component against the packing list to make sure that the correct catalog numbers
and quantities were received. Note any discrepancies.
6. Carefully inspect each item for damage. Check for detached, broken or bent parts, damaged
connectors, bent connector pins, and any other physical damage to the unit. Do not install
any product that is significantly damaged.
7. If there is any damage to the equipment, refer to “Contacting C-COR.net Technical
Support” on page v of this document for further instructions on how to proceed.
8. If the product is undamaged and all components are accounted for, discard packing material
if desired. You may still want to save some original shipping cartons and packing materials
for reuse should it become necessary to return any equipment.
Stop! You have completed this procedure.