BYD ECB16S-B, Руководство оператора

Страница: 23 / 43

OPERATING
ECB16S-B/ECB18S-B 44
ECB16S-B/ECB18S-B
45 OM-ECB16/18S-B2019001-EN
Travel
(1) When travelling, make sure that the load is well centered on the forks.
(2) After the load is placed on the forks, keep the mast tilted backwards and raise the forks
above the floor.
(3) During the travelling, do not tilt the mast forward or try raising the forks to avoid the
danger of forklift nose over and losing stability.
(4) If the stacked loads are high and affect the operator
’
s visibility of the route ahead,
operate the forklift in reverse except when the forklift is climbing the slope or inclines.
Warning
(1) When driving the forklift on a slope, keep the forks always facing the uphill direction and
downhill direction in contrast and drive in turtle speed mode.
(2) Do not cross or turn around on a slope.
Caution
(1) Have a second person as lookout if the visibility of the operator is reduced.
(2) Do not depress the brake pedal with a lot of force, since excessive force might cause
damage to the braking system.
Unloading
(1) Drive the forklift carefully up to the stacking destination and decelerate when approaching.
(2) Raise the forks to the proper height.
(3) Drive the forks and load into the shelf.
(4) Set the mast in the vertical position and lower the forks to the proper height until they get
separated from the forks.
(5) Slowly remove the forks from the bottom of the load.
(6) After driving the forks out, raise them and start the next.
Exiting
(1) Lower the forks fully after unloading.
(2) Apply the parking brake.
(3) Turn the key anticlockwise to OFF position and take it out.
(4) Press the emergency disconnect switch, release the seat belt and exit.
BATTERY
Charging
Open the charge port, and then connect the charger connector. Follow the user manual of the
charger to charge the forklift.
Note
(1) If the charge port cover is opened, traction is forbidden; close the charge port cover first,
and then traction is allow.
(2) The environment temperature influences the charging time, it's suggested the forklift be
charged at normal temperature.