PROTECTION & SAFETY
15
2021/07 - Version: C - Code : 34681
3.
Connection box
Drill the wall above the motor using a Ø 8 bit and mount the connection box.
4.
Wiring in the electrical panel
4.1.
Installation of the panel
The electrical control panel should be mounted on the wall of the plant housing, protected from sun and rain,
and at over 3.5 m from the pool.
The assembly steps are as follows:
4.2.
Reversing the electrical panel door swing
Take the door off its hinges.
Remove the hinges and the locks.
Invert and replace the hinges and locks.
Clip the door back onto its hinges.
Unscrew the 6 plastic screws and remove the front facing of the
electrical panel.
Remove the retaining screw from the mounting bracket at the
bottom of the electrical panel.
Use the mounting bracket as a drilling template.
Mount the bracket on the wall using the screws and bushings
provided.
Hang the electrical panel on the bracket and put the
retaining screw back in position.
Insert the cable glands and carry out wiring.
Replace the front facing once wiring is complete.
