Operation
Chapter 7
Operating the machine
Page 71
Version: 3/25/20
Translation of the original operating manual 116588
Bernard van Lengerich
Changing the drive speed by hand directly at the machine (optional)
7.5.6.1.1
With the receiving hopper filled and the machine switched off, use the adjusting screw (b) on the
flow control valve to set the drive speed of the dosing augers as follows:
Fig. 7-12: Setting the drive speed
Requirements:
The front, farmyard or wheel loader and the machine have been switched on (see
Chapter 7.5.1 "Switching the machine on").
There is no one in the danger area.
Work steps:
1.
Secure the front, farmyard or wheel loader and the machine against inadvertent start-
up and rolling away (see Chapter 6.4 "Switching off the front, farmyard or wheel loader
and securing it against inadvertent start-up and rolling away
“).
2.
Loosen the lock ring (a).
3.
Turn the adjusting screw (b) in/out:
3.1
Turn the adjusting screw (b) in.
Drive speed is increased.
3.2
Turn the adjusting screw (b) out.
Drive speed is reduced.
4.
Re-tighten the lock ring (a).
5.
Keep third parties (children) away from the front, farmyard or wheel loader.
6.
Start the front, farmyard or wheel loader and the machine (see Chapter 7.5.1
"Switching the machine on
“).
7.
Repeat the process if the desired spread quantity was not reached.
a
b
