Instruction manual
SPEEDLINER 8050WS - SPEEDLINER 9080WS
Code M0205 - rev.1.0
(11/2010)
BUTLER S.p.A.
Page 26/51
BUTLER Engineering & Marketing S.p.A. a s.u. -
Via Balduina 5/7 - 42010 Rio Saliceto (RE - Italy)
Tel. +39 0522 647911, Fax +39 0522 649760
e-mail: [email protected] / www.butler.it
Figure 27 shows wheel current position.
Upon procedure start, a “self-calibration” is carried out so that the position indicator is facing
up. Turn wheel rim by hand so as to allow the real-time displaying of wheel position and of
the corresponding position indicator. Update is made approx. every 3 times a second. The
first target is to turn wheel by 120° and reach the first highlighted point. Rotation can be
made in both directions, but it is nevertheless recommended to follow the direction shown by
the arrow to reach the indicated position more quickly.
As for models SPEEDLINER 9080WS, once the position indicator has reached the target
position, the screen Figure 29 will be displayed for approx. three seconds, which are enough
for the programme to acquire measurement readings.
As for models SPEEDLINER 8050WS, turn wheel by 120° and, once the target position is
reached, press detector keypad central key, as indicated on the screen Figure 28.
Figure 28
Figure 29 is displayed for approx. three seconds, which are enough for the programme to
acquire measurement readings. The red LED previously flashing on detector keypad (par.
3.7.3 on page 10) will turn off during data acquisition; then it will flash again:
Figure 29
Now you shall turn wheel until position indicator matches the second point, positioned at
about 240° from the starting position.
